Anatec Maxboat Catamaran Oak + DEVO7 Lithium Battery

Anatec Maxboat Catamaran Oak + DEVO7 Lithium Battery, The boat is a catamaran MAXBOAT type initiator, its typical form, ensures a perfect buoyancy and stability in any event even in the most extreme conditions (wind and waves). On each side of the hull, two broken engines give the power to navigate more than 7 km / h at full load (about 2 meters per second). The control of these motors is done independently of each other thereby steer the boat with incredible precision. This feature ensures perfect handling of the boat maxboat initiator and gives it the ability to turn in place. This is a major advantage when removing the lines must be very precise (along or under a canopy). Able to carry up to 5 kg of bait (2.5kg per bin), the max boat can deposit a large amount of bait in one single trip. Each tray has a separate opening, this feature increases the stability of the boat navigation while being capable of initiating multiple lines each way. Equipped with high quality electronic components, the boat max boat initiator respects the charter of quality and reliability common to all Anatec boats. A complete model with multiple functions for fishermen who want extreme put the odds on their side for a successful fisheries. Usable in any circumstance, the boat Anatec maxboat initiator has a ramp 6 high-visibility LEDs on the front and two red LEDs on the back. To facilitate the transport and the placing in water, Anatec maxboat is provided with a handle. Commissioning and launching the boat. Implementation of the main batteries. The batteries are supplied charged, but it may be useful to hand them over several hours during the first use of the boat. Before connecting the batteries, make sure the power switch is in the OFF position. Remove the cover by unscrewing the fixing butterflies, place the batteries in the housing provided for this purpose (each side of the hull) and perform their connection. Turning on the remote control. The DEVO 7 remote control works with eight 1.5V AA. To power the remote control, push the main switch to "ON" position (switch up). Closing the boat cover. Center the cover on the two plastic screws. Insert it gently and put butterflies tightening moderately. Turning on the boat. Before positioning the main switch to the ON position, make sure: - The remote is on and the battery charge level is satisfactory. - The batteries are connected properly in the boat. Launching and operation of the boat. Before navigating the vessel, it is preferable to perform a preliminary test run of the various components. If everything works correctly, follow the launching. Before removing the lines and priming fishing in real conditions, although it is advisable to take charge of the boat (driving and functionality). We strongly recommend to proceed with the first launching in a calm and shallow place and avoid the crowded shores of obstacles (branches, rocks). Remote DEVENTION DEVO7. The MAXBOAT come with DEVENTION DEVO7 remote that has 2.4GHz technology. This new technology is the ultimate in terms of remote control, it allows to solve the problems of unfortunate interference that cause the opening of the hatch or the dropping of lines at the wrong time. Also, when multiple users are within range, it is no longer necessary to make a change for quartz tuning to radio frequencies. The allocation of different channels automatically. Finally this new technology no longer requires an antenna on the boat, which greatly facilitates access under low branches. These new remotes, the transmission range up to 250m allowing to exclude any risk of loss of control. For his protection, the remote control is accompanied by a clear plastic cover that allows its use in case of rain. It is important to never use the remote control in the rain without protection. Charging the batteries and autonomy. Connect the output lead from the charger to the battery to be charged. Connect the charger to a power outlet 220 Volts. The charging time is 6 hours for a battery to 7.4V 12000mAh. Once charging is complete, disconnect the charger from the power outlet and disconnect.